Durable AAC All Aluminum Conductor , Bare Stranded Conductors In Transmission Lines

TANO CABLE Bare Stranded Conductor AAC 16mm2 35mm2 Cable

Application of AAC 95mm2

In comparison with copper, AAC conductors have considerable technical and economical advantages in the installation of overhead lines. Its characteristics, and low weight, combined with its high break1ng strength, are gathered which makes it possible to have large span runs, without having to revert to excessive mechanical stresses or to heavy metallic Towers. Due to the greater diameter of the conductors, electric losses by the corona Effect are greatly reduced. By making use of these properties economical electric energy transmission is attained at very high voltages and distances.
1. high tensile strength, allowing larger spans runs.
2. better sag properties, alowing longer span lengths.
3. economic design.
4. best suited for transmission lines with long spans.

Standard of AAC 95mm2

Basic design to DIN48201 – 5

Description of AAC 95mm2

Conductor(AAC,AAAC and ACSR) electronic cable have been widely used in power transmission lines with various voltage levels,because they have such good characteristics as simple structure,convenient installation and maintenance,low cost large transmission capacity.And they are also suitable for laying across rivers valleys and the places where special geographical features exist.

Parameters of AAC 95mm2

DIN48201 – 5

Construction of AAC 95mm2

Aluminum 1350 wires, concentrically stranded.

FAQ of AAC 95mm2

1. What kinds of products does TANO Cable manufacture?

1)Bare Conductor ,such as AAC,AAAC,ACSR,ACAR,AACSR,ACSR/AW and so on;

2)Aerial Bundled Cable (1kV-35kV ),such as Duplex,Triplex,Quadruplex Drop Wires and so on;

3)PVC Insulated (Flexible ) Wire ;

4) PVC Insulated and Sheathed (Armoured) Power Cable;

5)Low, Medium, High Voltage (1kV-220kV) XLPE Insulated (Armoured) Power Cable;

6)Welding Cable, Control Cable, Concentric Cable, Rubber Sheathed Cable and so on.

2. Which standards do you comply with when you produce the electrical wires and cables ?

We are able to produce electrical wires and cables based on GB, JB, IEC, BS, DIN, ASTM, JIS, NF, AS/NZS, CSA, etc. Meanwhile, we can design and manufacture the cables according to the samples and technical specification the customer supply.

3. What is the min.order quantity ?

It depends on the type and size of electrical wires and cables. For some small electrical wires, 100 meters can be accepted .But for the power cables with medium or high voltage, that should comply with the property of installed equipments. Anyhow,we will try our best to solve the problem and meet with the requirement If you have special request.

4. What is the production capacity per week or per month ?

For the bare conductor, we can finish 3000 tons within one month. For power cables, that depends on the type and size. The total output value per month is approx. USD3,000,000.00 for insulated aluminum cables and that is approx. USD8,000,000.00 for insulated copper cables.