SHD-GC Power 3 Conductor Power Cable , Special Power Cable Easy Handling

SHD-GC Power, Shielded Round Portable w/Ground-Check, EPR/CPE 2000 Volts, 90˚C, Three Conductor power cable

Product Construction
Conductor:
6 AWG thru 500 kcmil coated annealed copper, bunched wires, rope-lay-stranded per ASTM B172
Insulation:
Ethylene Propylene Rubber (EPR) insulation
Insulation Shield:
A flexible coated copper/textile braid shield isapplied over non-conducting overlapped tape
Ground-Check Conductor:
Annealed copper, rope-lay-stranded per ASTM B172, insulated with high-strength yellow polypropylene
Grounding Conductors:
Coated copper, rope-lay-stranded per ASTM B172 Two conductors in contact with the flexible copper braid shield
Jacket:
Reinforced, two-layer, extra-heavy-duty, leadcured Chlorinated Polyethylene (CPE)
Options:
Colored jackets are available
TPU (Thermoplastic Polyurethane) jacket
Applications:
• Designed for use as trailing cables on AC mining
equipment:
Where a ground-check conductor is required for fail-safe monitoring
With Bretby-type cable handling devices on long wall shearers
– Where induced voltages in the grounding system will not produce a hazard
– On low- and medium-voltage AC circuits where shielding is desired or required
Features:
• Flexible insulation shield provides shock hazard
protection
• Excellent heat, moisture, steam, oil, chemical and radiation resistance
Features (cont’d):
• Flexible for easy handling
• Resists cutting, impact, abrasion, flame and sunlight
• Excellent thermal stability and physical properties over a broad temperature range
• Two-layer jacket is reinforced to provide maximum protection from mechanical damage— the cause of most portable cable failures
Compliances:
• ICEA S-75-381 Portable and Power Feeder Cables for use in mines and similar applications
• Meets flame test requirements and is accepted for listing by MSHA
• Approved by the Pennsylvania Department of Environmental Protection
Packaging:
• Material cut to length and shipped on nonreturnable reels